TM-9-2330-356-14
SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1990
TM-9-2330-356-14 - Page 138 of 528
TM 9-2330-356-14
(h)
Remove cover and gasket from the
filter/separator and install filters (para 4-83). Replace
gasket and cover.
(i)
Remove and clean automatic drain
valve.
(3) Lubricate all points illustrated in lubrication
chart (fig. 3-1 through 3-6), regardless of interval.
(4) Couple an
authorized prime
mover
(para 1-10) to semitrailer. Perform a “break-in” by driving
25-30 miles at speeds up to 30 miles per hour. Check the
following:
(a)
While in motion, apply service brakes to
ensure that brakes are working properly.
(b)
Inspect marker lights, stop and turn
signal lights, blackout lights, and the control panel lights.
Replace if faulty.
(5) All deficiencies which appear to involve
unsatisfactory design shall be reported on DA Form 2407
(DA Pam 738-750).
d.
Correction of Deficiencies.
Deficiencies disclosed
during preliminary inspection and servicing or during the
“break-in” period shall be corrected by using organization
or supporting maintenance activity. Deficiencies shall be
reported in accordance with DA Pam 738-750.
Section II. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
4-2.
Special Tools and Equipment
4-4.
Fabricated Tools and Equipment
Special tools and equipment required for unit
maintenance of the semitrailers are listed in TM
Table 4-1 contains fabrication instructions for all tools
9-2330-356-24P. General mechanics tool sets and common
which must be fabricated by unit maintenance personnel
tool sets required for maintenance are authorized by the
for maintenance of this unit. Tables 4-2 through 4-7 list
Table of Allowance (TA) and the Table of Organization
bulk material and dimensions for fabrication of specific
and Equipment WOE).
electrical leads, harnesses and cables, tubes, conduits, and
chains.
4-3.
Repair Parts
Repair parts authorized for use by unit maintenance are
listed and illustrated in TM 9-2330-356-24P.
Table 4-1. Fabricated Tools and Equipment.
Nomenclature
Reference No. or NSN
Material Required
Pressure gage
NSN 6685-00387-9854
1 EA
Gladhand
MS35746-1
2 EA
Valve
11668037
1 EA
Tee
CPCXI, 120280
1 EA
Nipple
MS51846-42
3 EA
Bushing
MS51847-4
2 EA
Fabrication Instructions:
Assemble parts to create gladhand connector as shown
4-2
Back to Top
