TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 135 of 528

TM 9-2330-356-14

3-17. Underwing Nozzle (M970 and M970A1)

a.

Service.

The screen in the nozzle must be cleaned

periodically and whenever flow is restricted through the

nozzle.

(1) Remove nozzle (see

b

below).

(2)Unscrew adapter (fig. 3-30) from nozzle and

remove screen.

Figure 3-30. Removal of Screen From Underwing Nozzle.

WARNING

Dry cleaning solvent P-D-680 is toxic and

flammable.

Always wear

protective

goggles and gloves, and use only in a well-

ventilated area. Avoid contact with skin,

eyes, and clothes, and DO NOT breathe va-

pors. DO NOT use near open flame or ex-

cessive heat. The solvent’s flash point is

100°F-138°F (38°C-59°C). If you be-

come dizzy while using cleaning solvent,

immediately get fresh air and medical help.

If solvent contacts eyes, immediately wash

your eyes with water and get medical aid.

Compressed air used for drying or clean-

ing purposes must not exceed 30 psi

(207 kPa).

Wear protective clothing

(goggles and gloves) and use caution to

avoid injury to personnel.

(3) Clean the screen in dry cleaning solvent

(item 11, Appendix E). Use compressed air to remove any

excess material and to dry the screen.

b .

Removal.

(1) Move red sleeve (fig. 3-31) on coupling

toward nozzle. Then move red and silver sleeves

(fig. 3-31) back toward hose.

(2) Remove nozzle from coupling.

c .

Installation.

(1) Install nozzle into coupler.

(2) Move silver sleeve (fig. 3-31) on coupling

toward nozzle.

(3) Check for proper connection by trying to pull

the nozzle by hand from the hose.

Figure 3-31. Removal of Uderwing Nozzle

(M970 and M970A1).

3-18. Servicing Air Cleaner (fig. 3-32)

CAUTION

Do not run engine if red band is showing in

restriction Indicator. Damage to engine could

result.

a.

Service air cleaner whenever the restriction

indicator (fig. 3-32) shows a red band.

3-39