TM-9-2330-356-14
SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1990
TM-9-2330-356-14 - Page 257 of 528
4-66. Reflectors
a.
General.
Reflectors are located on the front, near
the marker lights, and on both ends of the hose trough.
b.
Replacement.
(1) Peel or scrape old reflector off semitrailer.
Clean surface thoroughly.
(2) Peel off reflector backing and place new
reflector in position.
4-67.
Identification and Instruction Plates
(Para 1-11)
NOTE
Some instruction plates have been mounted
with rivets. Drill rivets out and replace with
proper machine screw.
a.
Removal.
Remove screws holding plates to
semitrailer.
TM 9-2330-356-14
b.
Installation.
Fasten new plates to semitrailer with
screws.
4-68.
Fire Extinguisher Mounting Bracket.
(Figs. 4-95 and 4-96)
a.
Service.
Check tightness of mounting bolts and for
damage to retainer bracket.
b.
Replacement.
(1) Remove protective cover and fire
extinguisher.
(2) Remove four self-locking nuts, flatwashers,
and capscrews. Remove mounting bracket.
(3) Install new mounting bracket and fasten with
four capscrews, flatwashers, and self-locking nuts.
(4) Install fire extinguisher and protective cover.
Section XVII. MAINTENANCE OF ENGINE
4-69. General.
Detailed information concerning maintenance of the
engine assembly is found in Chapters 5 and 7 of this
manual. Procedures covering replacement of engine
components and accessories are contained in subsequent
paragraphs of this section.
4-70. General Engine Servicing
WARNING
Dry cleaning solvent P-D-680 is toxic and
flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO
NOT use near open flame or excessive heat.
The solvent’s flash point is 100°F-138°F
(38°C-59°C). If you become dizzy while
using cleaning solvent, immediately get fresh
air and medical help. If solvent contacts eyes,
Immediately wash your eyes with water and
get medical aid.
a.
Periodically clean all outside surfaces of the
engine with dry cleaning solvent (item 11, Appendix E).
b.
Clean battery and cables (para 4-23).
4-71. Crankcase, Cylinder Head, and Block
a.
Draining Crankcase.
(1) Place suitable container under crankcase
drain plug and remove drain plug (fig. 4-101). Drain oil
into container.
(2) When oil is completely drained, replace the
drain plug and refill crankcase with six quarts of oil. If
filter is replaced, add one additional pint of oil. Refer to
Lubrication Chart (figs. 3-1 through 3-6) for correct type
of oil. Wipe up any spills and dispose of used oil according
to regulations.
4-121
Back to Top
