TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 262 of 528

TM 9-2330-356-14

TA502360

Figure 4-107. Throttle Linkage Connection at Engine.

b.

Throttle Cable Adjustment.

NOTE

Engine should be adjusted to low idle speed

(900 rpm).

(1) Remove engine panel door by loosening the

two retaining screws (fig. 4-101) and lifting door out.

(2) Start engine (para 2-10).

(3) To increase engine speed, loosen the throttle

jam nut on the outside of the panel and tighten the inside

jam nut (fig. 4-107).

(4) To decrease engine speed, loosen the inside

jam nut and tighten the outside jam nut.

(5) Shut off engine (para 2-10).

(6) Replace engine panel door.

c. Removal.

(1) Remove engine panel door by loosening the

two retaining screws (fig. 4-101) and lifting door out.

(2) Remove clevis pin and cotter pin (fig. 4-107)

from end of throttle cable. Disconnect throttle cable from

throttle rod.

(3) Remove yoke and jam nut from end of

throttle cable.

(4) Remove inside jam nut and pull cable through

shrouding.

(5) Remove screw and handle from cable

(fig. 4-108).

(6)

(7)

(8)

(9)

Remove packing nut, jam nut, and washer.

Pull cable through channel of control panel.

Cut and remove straps that support cable.

Remove cable.

TA099848

Figure 4-108. Throttle Linkage Connection at

Control Panel.

4-126