TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 836 of 1364

TM 9-2350-238-20-1
2-139. MAINTENANCE OF AUXILIARY DRIVE SHAFTS, UNIVERSAL JOINTS, AND
RELATED PARTS (CONT).
Do not clean lubricant from new bearings; keep new bearings wrapped until ready for
installation.
NOTE
Installation steps are written for one universal joint but apply to all six universal joints.
1
Place a wood block under propeller shaft (1) adjacent to shaft yoke (2).
2
Rotate propeller shaft (1) until ends of shaft yoke (2) are vertical.
3
Install cross assembly (3) into shaft yoke (2).
4
Place bearing (4) in position in top opening of shaft yoke (2).
5
Engage bearing surface of cross assembly (3) into bearing (4) and hold in position. Seat bearing.
6
Rotate propeller shaft (1) 180 degrees.
7
Place bearing (5) in position in opening of shaft yoke (2).
2-810


Back to Top