TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 860 of 1364

TM 9-2350-238-20-1

2-144. MAINTENANCE OF TORSION BAR SOCKETS.

This task covers:

a.

Removal

b.

Inspection/Repair

c. Installation

INITIAL SETUP

Materials/Pads

References

Dry cleaning solvent (item 16, appx C)

TM 9-2350-238-24P-1

Gasket

Gasket (9)

Equipment Conditions

Grease (item 20, appx C)

2-848 Roadwheel or idler wheel removed

Lockwasher (60)

2-827 Torsion bar removed

1

2

3

4

5

NOTE

Procedure is written for one torsion

bar socket, but applies to all ten

torsion bar sockets.

Remove four hexagon head capscrews (1)

and four Iockwashers (2).

NOTE

Do not remove two hexagon head

capscrews and two Iockwashers

securing anchor retainer to torsion

bar socket.

Insert two hexagon head capscrews (1)

into two jackscrew holes (3).

Tighten two hexagon head capscrews

evenly to separate anchor retainer (4)

from hull.

(1)

Remove anchor retainer (4) with attached

torsion bar socket (5).

Remove two hexagon head capscrews (1)

from jackscrew holes (3).

2-834