TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 867 of 1364

TM 9-2350-238-20-1
17
18
19
20
21
22
23
24
25
26
27
Install two threaded straight pins in
opposing capscrew holes on hull.
Coat sealing surfaces of roadwheel pivot
arm assembly (9) and hull with sealing
compound.
Position roadwheel pivot arm assembly (9)
on threaded straight pins.
Push roadwheel pivot arm assembly (9)
into hull until end of spindle is visible in
road wheel lever cavity.
Insert and position roadwheel lever (22)
into road wheel lever cavity.
Position roadwheel lever (22) so blind
spline on lever arm mates with blind spline
on roadwheel arm spindle.
Remove two threaded straight pins.
Install and tighten six hexagon head
capscrews (23) and six new Iockwashers
(24) in cross-pattern sequence.
Install eye of lockout cylinder assembly
(25) into arm of roadwheel lever (22).
Install straight headless pin (26) and two
new cotter pins (27).
Lubricate roadwheel and hub assembly.
Refer to TM 9-2350-238-10.
2-841


Back to Top