TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 909 of 1364

TM 9-2350-238-20-1

2-155. MAINTENANCE OF LOCKOUT CYLINDER AND RELATED PARTS.

This task covers:

a.

Removal

b.

Inspection/Repair

c. Installation

INITIAL SETUP

Tools and Special Tools

NOTE

Automotive maintenance and repair shop

The following equipment condition

equipment: organizational maintenance,

applies to the right side number 4

common no. 1 (less power) (item 80,

lockout cylinder.

appx B)

●

Hammer puller

Cab traversed to the left

Plier wire twister (item 30, appx G)

(TM 9-2350-238-10)

Sling (item 82, appx B)

NOTE

Materials/Parts

The following equipment conditions

Corrosion preventive sealant (item 35,

apply to the left side number 2

appx c)

lockout cylinder.

Cotter pin (32)

Hydraulic fluid (item 21, appx C)

2-952 Driver’s seat removed

Lockwire (item 23, appx C)

2-840 Batteries removed

Masking tape (item 45, appx C)

2-840 Battery compartment tray removed

Preformed packing (2)

General Safety Instructions

References

TM 9-2350-238-10

TM 9-2350-238-24 P-I

Removing plugs and compressing

Personnel Required

cylinder may cause hydraulic fluid to

Two

spill. Wipe up any spilled hydraulic

fluid.

Equipment Conditions

NOTE

The following equipment condition

applies to the right side number 1 and

number 2 lockout cylinders.

2-384 Powerplant removed

2-883