TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 155 of 495

WARNING

TM 9-2350-238-20- 2

16

Install knob (28) on threaded straight pi n

(29) .

Dry cleaning solvent is toxic an d

17

Install threaded straight pin (29), helica l

flammable. Wear protective goggle s

compression spring (30), and shaft colla r

and gloves and use only in well-

(31) on cab seat frame (27) .

ventilated areas .

18

Install headless straiaht pin (32) i n

12

If nonmetallic bumper (26) was removed ,

threaded straight pin (29).

use dry cleaning solvent (item 10, appx

C) and wire brush to remove residua l

adhesive from cab seat frame (27) .

13

Apply epoxy resin adhesive (item 2, app x

C) to bonding surface of new nonmetalli c

bumper (26) .

14

Install new nonmetallic bumper (26) t o

cab seat frame (27) .

19

Install right bearing plate (33), left bear -

ing plate (34), double angle bracket (35) ,

right retaining strap (36), and cab sea t

frame (27) on rigger and gunner sea t

support (20) .

20

Install six hexagon capscrews (37), si x

new Iockwashers (38), and six hexago n

plain nuts (39) .

15

Apply sealing compound (item 17, app x

C) to threads of knob (28) .

2-11 5