TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 178 of 495

WARNING

WARNING

TM 9-2350-238-20- 2

2-47. MAINTENANCE OF TOW WINCH CABLE WIRE ROPE ASSEMBLY (CONT) .

REMOVAL (CONT )

Always wear leather gloves whe n

handling winch cable. Never allo w

cable to run through hands. Do no t

operate winch crane with less tha n

four turns of wire rope on drums .

Failure to observe these warnings

could result in personnel injuries .

4

Pay out tow winch cable wire rop e

assembly (3) until about 12.00 in. (30.4 8

cm) of cable remains on tow winch dru m

(4). Refer to TM 9-2350-238-10 .

5

Release tension on tow winch cable wir e

rope assembly (3) and remove tow winc h

cable wire rope assembly from tow winc h

drum (4) .

INSPECTION/REPAIR

1

Inspect for broken, damaged, or missing parts .

2

Repair is by replacement of authorized parts (TM 9-2350-238-24P-2) .

INSTALLATIO N

Make sure ail personnel stand clear of boom and block before traversing cab .

1

Turn cab until boom is at rear of vehicle .

2

Raise boom to 45 degrees .

2-13 8