TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 179 of 495

WARNING

TM 9-2350-238-20- 2

Always wear leather gloves whe n

handling winch cable. Never allo w

cable to run through hands. Do no t

operate winch or crane with less

than four turns of wire rope o n

drums. Failure to observe these war-

nings could result in personne l

injuries .

3

Install ferrule (1) in socket (2) with fla t

side of ferrule (1) flush with tow winc h

drum (3) .

4 Attach clevis (4) of cable wire rop e

assembly (5) to 15.00 ft (4.57 m) tie lin e

cable or chain capable of supportin g

30,500

lb

(13,847

kg)

line

pull.

5

Attach other end of tie line cable or chai n

to anchor capable of supporting 30,500 l b

(13,847

kg)

line

pull.

6

Move vehicle until slack is removed fro m

cable and set driver shift control lever (6)

to N (neutral) .

7

Set HYDR PUMP PTO CLUTCH switch (7 )

to ON .

8

Pull hand throttle push-pull control (8 )

completely out .

2-13 9