TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 171 of 495

TM 9-2350-238-20- 2

9

1 0

NOT E

Measure length center to center o f

lower linkage controls prior to disas-

sembly of clevises and nuts fro m

rods and shaft to assure accuracy

upon reassembly .

Loosen three hexagon plain nuts (21) .

Remove one end of two hydraulic valv e

shift rods (22 and 23), and hydraulic

valve shift stud (24), and three hexago n

plain nuts (21) from three rod end cle-

vises (13) .

Loosen three hexagon plain nuts (25) .

Remove other end of two hydraulic valv e

shift rods (22 and 23), and hydraulic

valve shift stud (24), and three hexago n

plain nuts (25) from three rod en d

clevises (26) .

11

Remove three cotter pins (27) and thre e

headed straight pins (28), releasing thre e

boom and tow winch manual contro l

levers (29) from mounting plates (30) o f

camlock controls support (8) .

12

Remove three shift lever handle knob s

(31), three hexagon plain nuts (32) ,

three tiedown straps (33), and three shif t

handle boots (34) from three boom an d

tow winch manual control levers (29) .

Remove three boom and tow winc h

manual control levers .

13

Remove two hexagon capscrews (35) ,

two Iockwashers (36), two flat washer s

(37), and winch control panel bracke t

(38) from camlock controls support (8) .

2-13 1