TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 172 of 495

TM 9-2350-238-20- 2

2-46. MAINTENANCE OF BOOM ELEVATING, BOOM AND TOW WINCH CONTROL S

AND LINKAGE (CONT) .

REMOVAL (CONT )

14

If damaged, remove four drive screw s

tion plate (51) from camlock control s

(39) and load rating capacities identifica-

support (8) .

tion plate (40) .

21

If damaged, remove two drive screw s

15

If damaged, remove four drive screw s

(41) and winch load instruction plat e

(42) .

16

If damaged, scrape or pry off high nois e

instruction plate (43) using putty knife .

17

If damaged, remove two drive screw s

(44) and LO-N-HI instruction plate (45)

from camlock controls support (8) .

18

If damaged, remove two drive screw s

(46) and BOOM WINCH LOWER-RAIS E

instruction identification plate (47) fro m

camlock controls support (8) .

19

If damaged, remove two drive screw s

(48) and TOW WINCH OUT IN identifica -

tion plate (49) from camlock control s

support (8) .

20

If damaged, remove two drive screw s

(50) and BOOM LOWER RAISE identifica-

(52) and filter bypassing instruction plat e

(53) from camlock controls support (8) .

22

If damaged, remove two drive screw s

(54) and tow winch brake pressur e

selector identification plate (55) from ca b

assembly winch controls access cove r

(2) .

23

If damaged, remove two drive screw s

(56) and boom winch brake pressur e

identification plate (57) from cab assem-

bly winch controls access cover (2) .

INSPECTION/REPAIR

1

Check for broken, damaged, or missin g

parts .

2

Repair is by replacement of authorize d

parts (TM 9-2350-238-24P-2) .

2-13 2