TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 174 of 495

TM 9-2350-238-20- 2

2-46. MAINTENANCE OF BOOM ELEVATING, BOOM AND TOW WINCH CONTROL S

AND LINKAGE (CONT) .

INSTALLATION (CONT )

12

Install winch control panel bracket (22 )

on camlock controls support (7) an d

secure with two flat washers (23), tw o

new Iockwashers (24), and two hexago n

capscrews (25) .

13

Install three shift handle boots (26) ,

three new tiedown straps (27), and thre e

hexagon plain nuts (28) on three boo m

and tow winch manual control lever s

(29) .

14

Apply sealing compound (item 17, app x

C) to threads in three shift lever handl e

knobs (30) and install on three boom an d

tow winch manual control levers (29) .

NOT E

Check measurement of lower contro l

linkage controls after reassembly o f

clevises and nuts to rods prior to in-

stallation to manual control levers .

15

Install three boom and tow winch manua l

control levers (29) to mounting plates

(31) of camlock controls support (7) an d

secure with three headed straight pins

(32) and three new cotter pins (33) .

16

Install three hexagon plain nuts (34) o n

one end of two hydraulic valve shift rods

(35 and 36), and hydraulic valve shif t

stud (37). Install two hydraulic valv e

shift rods and hydraulic valve shift stu d

into three rod end clevises (38) an d

tighten three hexagon plain nuts (34) .

17

Install three hexagon plain nuts (39) o n

other end of two hydraulic valve shif t

rods (35 and 36), and hydraulic valv e

shift stud (37). Install two hydraulic

valve shift rods and hydraulic valve shif t

stud into three rod end clevises (40) an d

tighten three hexagon plain nuts (39) .

2-13 4