PRE-ASSEMBLY INSPECTION
1.
Inspect oxygen hose for damage or wear prior to and immediately following each use of the
exothermic cutter.
2.
Inspect ignition power cables and connectors for damage or wear prior to and immediately following each
use of exothermic cutter.
3.
Inspect torch for damage or wear prior to and immediately following each use.
4.
Inspect flash arrestor and flash arrestor screen prior to and immediately following each use of
exothermic cutter.
END OF TASK
INSTALLING OXYGEN CYLINDER REGULATOR VALVE
1.
Remove protective cap (Figure 1, Item 1).
2.
Position regulator valve (Figure 1, Item 2) so gauges can be easily read.
3.
Align regulator valve (Figure 1, Item 2) and tighten nut (Figure 1, Item 3).
Figure 1.
Oxygen Cylinder Regulator Valve.
END OF TASK
TM 9-2350-256-10
0052
0052-3