TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 278 of 796
CONNECTING EXOTHERMIC CUTTER - Continued
CAUTION
•
The battery may discharge if the striker plate contacts the work area. Prevent
continuous contact which may completely drain the battery. Failure to comply may
result in damage to equipment.
•
When electric arc or resistance welding on a vehicle with sensitive electrical
equipment, follow these precautions to avoid damage to electrical equipment.
•
Ensure the power cable is disconnected from the equipment, not the control panel.
Failure to comply may result in damage to electrical equipment.
•
Welding ground point must be located as close as possible to the welding area. If
electrical equipment is located between the areas being welded and welding
ground point, REMOVE THE ELECTRICAL EQUIPMENT. Failure to comply may
result in damage to electrical equipment.
5.
Install slave receptacle adapter (Figure 3, Item 1) in slave receptacle (Figure 3, Item 3).
6.
Connect cable (Figure 3, Item 2) to slave receptacle adapter (Figure 3, Item 1).
Figure 3.
Exothermic Cutter.
END OF TASK
TM 9-2350-256-10
0052
0052-6
Back to Top
