TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 445 of 796
AUTOMATIC FIRE EXTINGUISHER SYSTEM (AFES) TROUBLESHOOTING, IF EQUIPPED
INITIAL SETUP:
Materials/Parts
Lens paper (WP 0134, Table 1, Item 55)
Personnel Required
Crewman (3)
References
Description and use of operator's controls and
indicators (WP 0004)
Starting main engine (WP 0010)
WARNING
•
Throughout troubleshooting of the electrical system or electrical components, be
certain vehicle MASTER switch (WP 0004) is off between every step unless
otherwise directed. Failure to comply may result in personnel death or injury.
•
Remove any rings, bracelets, wristwatches, and neck chains before working on
any vehicle. Jewelry can catch on equipment and cause injury, or may short
across electrical circuit and cause severe burns or electrical shock. Failure to
comply may result in personnel death or injury.
TROUBLESHOOTING PROCEDURE
CONTROL ELECTRONICS PANEL (CEP) SYSTEM ON LIGHT EMITTING DIODE (LED) DOES NOT LIGHT
WHEN VEHICLE POWER IS ON
SYMPTOM
Control Electronics Panel (CEP) SYSTEM ON Light Emitting Diode (LED) does not light when vehicle power
is on.
MALFUNCTION
CEP does not power up.
CORRECTIVE ACTION
1.
Check battery indicator gauge (WP 0004) to see if batteries have a proper charge.
2.
Check for loose or disconnected wiring harnesses and leads.
3.
Tighten and/or connect wiring harnesses and leads.
4.
If battery indicator gauge indicates a low charge, start main engine (WP 0010) and charge
batteries if required.
5.
If CEP fails to power up, notify maintenance.
TM 9-2350-256-10
0082
0082-1
Back to Top
