TM 9-2350-260-20-1-2
ENGINE OIL LEVEL GAGE CAP REPLACEMENT (2A ENGINE) (Sheet 4 of 4)
8.
Position bracket (J) with valves (K) and fuel drain hoses (L) onto cover and engine.
9.
Using 1/2 inch socket install and tighten two screws (M) securing bracket (J).
10.
Position drain hoses (L) into straps (G) and bend straps (G) over hoses (L).
11.
Position drain tubes (N) onto valves (K).
Using 3/8 inch wrench, tighten tube nuts onto valves.
12.
Open cap assembly (A) and insert oil level gage.
13.
Install powerplant (page 5-14).
End of Task
TA147491
6-37