TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 234 of 772

TM 9-2350-260-20-1-2

ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (2D ENGINE) (Sheet 4 of 4)

5.

Using two 1-1/2 inch wrenches, install hose (E) to

fitting (F).

6.

Using screwdriver and 3/8 inch wrench, install

clamp (G) on hose (E) if removed during

disassembly.

7.

Position new sealing washer (H) over vent hole.

8.

Using 9/16 inch wrench, install vent bolt (J)

through washer (H).

9.

Using socket and torque wrench, tighten drain

valve (K) to a minimum of 150 lb-in (17 N

•

m).

Do

not overtighten.

10.

Perform ground hop (page 5-57).

Run engine at

idle until oil temperature is in normal operating

range (TM 9-2350-260-10).

11.

Check oil level.

Add oil as required (LO

9-2350-260-12.

12.

Disconnect ground hop kit (page 5-67).

13.

Install powerplant (page 5-40).

End of Task

6-157