TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 238 of 772

TM 9-2350-260-20-1-2

THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT) REPLACEMENT (Sheet 4 of 4)

INSTALLATION:

NOTE

If replacing valve assembly, the engine oil cooler bypass valve also must be

replaced.

Go to page 6-13 for replacement.

1.

Install new spacer ring (B) on valve (A).

2.

Seat threads of valve (A) in engine oil cooler

socket (C) by hand.

3.

Using wrench, tighten valve (B).

4.

Replace left engine cooler (2A engine, page

6-125) (2D engine, page 6-131) (if required).

5.

Connect engine oil return hose to fitting (2A engine, page 6-127, steps 18 and 19) (2D engine, page 6-132, steps

14 and 15).

6.

Tighten engine oil drain valve (2D engine, page 6-133, step 17) (2D engine).

7.

Tighten engine oil filter vent bolt (2D engine) (page 6-133, steps 18 and 19).

8.

Check engine oil level indicator gage rod (TM 9-2350-260-10).

9.

Replenish lubricating oil lost during valve assembly replacement.

10.

Perform ground hop (page 5-57).

11.

Install 2A powerplant (page 514) or 2D powerplant (page 5-40).

End of Task

TA147610

6-161