TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 279 of 772

TM 9-2350-260-20-1-2

PURGE FUEL SYSTEM (2D ENGINE) (Sheet 1 of 2)

TOOLS:

7/16 in. combination box and open end wrench

Flashlight

PERSONNEL:

Two

REFERENCE:

TM 9-2350-260-10

PRELIMINARY PROCEDURE:

Remove upper engine access cover (page 16-44)

PURGING:

1.

Using wrench and flashlight, reach through access

and loosen fuel filter bleed cap (A).

2.

Set

FUEL

PUMPS

switch

to

ON

(TM

9-2350-260-10).

3.

Set MASTER CONTROL switch to ON (TM

9-2350-260-10.

NOTE

If no air bubbles are observed in step

4, go to step 7.

4.

Observe for air release bubbles from bleed cap

(A).

5.

Set MASTER CONTROL switch to OFF (TM 9-2350-260-10).

6.

Wait approximately one minute, then repeat steps 3 and 4 until a constant fuel flow is observed from bleed cap (A).

7.

Using wrench, tighten bleed cap (A).

8.

Set MASTER CONTROL and FUEL PUMPS switches to OFF (TM 9-2350-260-10).

Go on to Sheet 2

TA148085

7-10