TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 270 of 772

TM 9-2350-260-20-1-2

OIL COOLERS - CLEANING (Sheet 3 of 3)

4.

Squeeze lever (F) to obtain an air-liquid mixture

and spray fins (E) with cleaning solution.

Allow

time for solution to soak between oil cooler fins.

5.

Clean oil coolers by alternately moving cleaner

head (D) from left to right and up and down.

Cleaning solution flows freely through entire oil

cooler area.

NOTE

If oil coolers were cleaned with

powerplant installed, use hose and

water to make sure oil cooler screens

are clear.

6.

When oil cooler fins (E) are clean, use hose to

flush with water.

7.

Dry all parts with air by removing end of siphon

hose (B) from cleaning solution container (C) and

squeezing lever (F).

8.

Remove engine opening protective coverings.

9.

Close hull drains (TM 9-2350-260-10).

10.

Install engine access covers (2A engine, pages 6-78 and 6-86) (2D engine, pages 6-82 and 6-91).

11.

Install engine shroud (page 9-3).

12.

Install screens, if removed (pages 6-117 and 6-119).

13.

Install top deck (page 16-22).

End of Task

TA147639

6-193/(6-194 blank)