TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 268 of 772

TM 9-2350-260-20-1-2

OIL COOLERS - CLEANING (Sheet 1 of 3)

TOOLS:

Oil cooler cleaning tool

SUPPLIES:

Detergent (Item 33, Appendix D)

Water source

50 to 90 psi air supply

Water hose

Container for cleaning solution

REFERENCE:

TM 9-2350-260-10

PRELIMINARY PROCEDURES:

Remove top deck (page 16-20)

Remove engine shroud (page 9-2)

Remove engine access covers (2A engine, pages 6-77 and 684) (2D engine, pages

6-79 and 6-88)

Open hull drains (TM 9-2350-260-10)

CLEANING:

NOTE

For any engine, the oil cooler cleaning tool will clean the two engine oil coolers as

well as the two transmission oil coolers with the powerplant in or out of the tank.

This applies to both the 2A and the 2D engines.

If oil coolers are to be cleaned with powerplant removed, oil cooler screens must

be removed as part of preliminary procedures (pages 6-116 and 6-118).

WARNING

Always wear safety glasses or goggles when cleaning oil coolers to prevent dirt

particles and cleaning agent from splashing in eyes.

Go on to Sheet 2

TA147637

6-191