TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 259 of 772

TM 9-2350-260-20-1-2

ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (INNER AND OUTER) REPLACEMENT (2A ENGINE)

(Sheet 5 of 5)

9.

Place tube assembly (H) in position and, using

1-1/2 inch wrench, tighten jamnut (Q).

10.

Place tube assembly (L) in position and, using 1-

1/2 inch wrench, tighten jamnut (R).

11.

Replenish lubricating oil (Item 43, Appendix D) lost

during oil line tube assemblies removal.

12.

Connect powerplant for powerplant ground hop (page 5-54).

13.

Start and run engine (TM 9-2350-260-10).

Check for oil leaks at oil cooler and transmission oil line tube assembly

connections.

14.

Shut down powerplant (TM 9-2350-260-10).

Disconnect powerplant from ground hop (page 5-67).

15.

Install engine shroud (page 9-).

16.

Install rear engine shroud support (page 9-5).

17.

Install powerplant (page 5-14).

End of Task

TA147628

6-182