TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 252 of 772

TM 9-2350-260-20-1-2

THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (LEFT SIDE) TEST AND REPLACEMENT (2D

ENGINE) (Sheet 4 of 6)

8.

Using 1-1/2 inch wrench, remove tube end fitting )

from adapter (H).

9.

Using hands, displace tube (K).

10.

Using 1-5/8 inch wrench, remove adapter (H).

11.

Using automotive wrench, remove valve assembly

and spacer ring (L).

Throw spacer ring away.

TEST:

1.

Using heat source (A), heat container (B) of clean

water to boiling.

2.

Using ruler, measure overall length of valve at

room temperature.

Write down overall length of

valve.

3.

Using wire, wrap one end tightly around threads

(C) of valve.

4.

Place valve in boiling water just so valve is

covered.

Let free end of wire hang over edge of

container.

5.

After about 30 seconds, use free end of wire to

take valve out of water.

Go on to Sheet 5

TA147621

6-175