TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 253 of 772

TM 9-2350-260-20-1-2

THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (LEFT SIDE) TEST AND REPLACEMENT (2D

ENGINE) (Sheet 5 of 6)

6.

Using ruler, measure overall length of valve.

Write down overall length of valve.

7.

Compare measurements written down at room temperature and at heated temperature.

WARNING

Compressed air used for cleaning purposes will not exceed 30 psi.

Use only with

effective chip guarding and personal protective equipment (goggles/shield, gloves,

etc.).

8.

Using low-pressure compressed air, dry valve.

NOTE

After heating, valve length must have increased by 1/4 inch minimum.

If valve

length increased less than 1/4 inch, throw valve away.

Obtain new valve and

repeat test.

If new valve passes test install it.

INSTALLATION:

1.

Install new spacer ring (A) on valve (B).

2.

Using hands, install valve (B) to transmission oil

cooler.

3.

Using automotive wrench, tighten valve (B).

4.

Using 1-5/8 inch wrench, install inside adapter (C).

5.

Using hands, install tube end fitting (D) on adapter

(C).

6.

Go to other end of tube (E).

Go on to Sheet 6

TA147622

6-176