TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 265 of 772

TM 9-2350-260-20-1-2

ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (LEFT INNER AND OUTER) REPLACEMENT (2D

ENGINE) (Sheet 2 of 4)

NOTE

Place rags (Item 65, Appendix D) under fittings (J), (A), (K), and (C).

Upon

removing tubes and fittings, seal powerplant openings with plastic barrier material

(Item 41, Appendix D) and masking tape (Item 57, Appendix D) to prevent

unnecessary exposure to moisture and contamination.

Remove plastic barrier

material and masking tape when installing tubes and fittings.

REMOVAL:

1.

Using 1-5/8 inch wrench to hold adapter (A), use 1-1/2 inch wrench and loosen connector (B).

2.

Using 1-5/8 inch wrench to hold adapter (C), use 1-1/2 inch wrench and loosen connector (D).

3.

Using hands, disconnect and remove tube (E) from powerplant.

4.

Using 1-5/8 inch wrench, remove adapters (A) and (C) and gaskets (F) and (G).

Throw gaskets away.

5.

Using 1-5/8 inch wrench to hold adapter (H), use 1-1/2 inch wrench and loosen connector (J).

6.

Using 1-5/8 inch wrench to hold adapter (K), use 1-1/2 inch wrench and loosen connector (L).

7.

Using hands, disconnect and remove tube (M) from powerplant.

8.

Using 1-5/8 inch wrench, remove adapters (H) and (K) and gaskets (N) and (P).

Throw gaskets away.

Go on to Sheet 3

TA147634

6-188