TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 282 of 772

TM 9-2350-260-20-1-2

INSPECT FUEL INJECTOR NOZZLES AND HOLDERS (Sheet 2 of 3)

CAUTION

Do not exceed 700 to 750 rpm and do not run engine for more than 10 minutes at a

time.

Before restarting, allow engine to cool.

2.

Start engine (TM 9-2350-260-10).

3.

Place hand between nozzle heads (D) and top of holders (E) on each fuel injector.

If movement is felt, stop the

engine.

If movement is not felt, go to step 7.

4.

Using torque wrench (F) and fixed open end wrench (G) (Item 3, Chapter 3, Section I) tighten nozzle holders (E) to

42 lb-ft (57 N

•

m).

5.

Start engine (TM 9-2350-260-10).

6.

Place hand between nozzle heads (D) and top of holders (E) on each fuel injector.

If movement is still felt, notify

support maintenance.

Go on to Sheet 3

TA148088

7-13