TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 338 of 772

TM 9-2350-260-20-1-2

PERSONNEL HEATER FUEL PUMP REPLACEMENT (Sheet 3 of 3)

INSTALLATION:

1.

Using 1/2 inch wrench, install elbow (A) into pump

(B).

2.

Using 7/16 inch wrench, install elbow (C) into

pump (B).

NOTE

When installing heater pump, make

sure cable condenser bracket is

secured

with

pump

mounting

bracket.

NOTE

Be sure elbows (A) and (C) are alined

with the chalk marks on the pump.

3.

Mount condenser bracket and fuel pump (B) to plate.

Using fingers, install two screws (D) and flat washers (E).

4.

Install two new lockwashers (F) and nuts (G) to

other side of mounting plate.

5.

Using socket, tighten screws (D) while holding nuts

(G) with 7/16 inch open end wrench.

6.

Using 5/8 inch wrench, connect and tighten nut (H)

to connect hose (J) to 45

°

elbow.

7.

Using 9/16 inch wrench, connect and tighten nut

(K) of tube (L) to 90

°

elbow.

8.

Plug electrical connector (M) to harness (N).

9.

Operate personnel heater (TM 9-2350-260-10).

End of Task

TA148144

7-69