TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 352 of 772

TM 9-2350-260-20-1-2

AIR CLEANER INTAKE AND HOSE REPLACEMENT (Sheet 2 of 5)

REMOVAL:

1.

Using wrench, loosen clamp nut (A) at end of intake hose (B).

2.

Slide clamp (C) over intake hose (B) to middle of hose.

3.

Using screwdriver, pry hose (B) from elbow (D) and remove clamp (C).

4.

Close grille doom and go inside turret.

5.

Traverse turret to gain access to air intake.

6.

(Early M60).

Using 1/2 inch socket remove four

assembled screws and washers (E).

Throw

screws away.

7.

(Late M60).

Using 1/2 inch socket, remove four

screws and lockwashers (E).

Throw lockwashers

away.

8.

Remove cover and gasket (F).

9.

Inspect gasket cemented to cover (F).

If damaged,

use putty knife and remove gasket.

Apply

adhesive (Item 2, Appendix D) to new gasket and

potion onto cover.

10.

Using 9/16 inch socket, remove eight nut and

lockwashers (G).

Throw lockwashers away.

11.

Remove air intake flange assembly (H) and hose.

12.

Inspect gasket (J) cemented to bulkhead.

If

damaged, use putty knife and remove gasket.

Apply adhesive (Item 2, Appendix D) to new

gasket (J) and position on bulkhead.

Go on to Sheet 3

TA148158

7-83