TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 433 of 772

TM 9-2350-260-20-1-2

FUEL TANK (RIGHT) FILLER REPAIR (Sheet 5 of 6)

INSTALLATION:

1.

Install strainer (A) in fuel tank (B).

2.

Install filler neck (C) on fuel tank (B).

3.

Using screwdriver, secure filler neck (C) to fuel

tank (B) using eight screws (D).

4.

If required, use slip joint pliers and install lockwire

(Item 59, Appendix D) (E) in eight screws (D).

5.

Using two new gaskets (F) and new washers (G),

assemble seal assembly (H) and install eight new

screws (J) finger tight

6.

Install seal assembly (H) on filler neck.

While

holding filler neck in position, use screwdriver and

tighten screws (J) until gaskets (F) and (G) are

compressed to form tight seal between filler neck

and hull.

Go on to Sheet 6

TA148239

7-164