TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 626 of 772

TM 9-2350-260-20-1-2

MANIFOLD HEATER IGNITION COIL AND CABLE REPLACEMENT (2D ENGINE) (Sheet 3 of 3)

INSTALLATION:

1.

Position two clamps (A) onto coil (B).

2.

Position coil (B) and clamps (A) on frame.

3.

Install two screws (C) to secure clamps (A) to

frame.

Do not tighten.

4.

Connect cable (D) to coil (B).

5.

Using 7/8 inch wrench, tighten lead.

6.

Using 1/2 inch socket and 1/2 inch wrench, install

two screws (E) to hold bracket (F) to frame.

7.

Using 7/16 inch socket, install two screws (G) and

clamp (H) to bracket (F).

8.

Route cable (D) over bracket and connect to spark

plug.

9.

Using 3/4 inch wrench, tighten cable (J).

10.

Using 1/2 inch socket, tighten screws (C).

11.

Alining keyway, connect electrical connector (K) to

coil (B).

12.

Using spanner wrench, tighten electrical connector

(K).

13.

Perform manifold heater operational check (page

7-324).

14.

Install powerplant (page 5-40).

End of Task

TA148432

7-357