TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 98 of 772
TM 9-2350-260-20-1-2
AUXILIARY OIL FILTER REPLACEMENT (2A ENGINE) (Sheet 2 of 5)
REMOVAL:
1.
Place rags (Item 65, Appendix D) and container
under oil filters to catch drained oil.
2.
Using 1/2 inch socket, remove eight self-locking
nuts and flat washers (A) from oil filter (B).
Throw
self-locking nuts away.
3.
Using 1/2 inch wrench, loosen stop bolt (C).
4.
Install two jackscrews into oil filter (B).
5.
Using 1/2 inch socket on jackscrews, turn
jackscrews evenly into filter (B) to separate filter
from housing.
When filter is separated from
housing, remove both jackscrews from filter (B).
6.
Grasp handle (D) by hand and pull filter (B) out of
housing to stop bolt and let oil drain out of housing
into container.
7.
Remove filter (B) from housing and throw away
gasket (E) on housing.
Go on to Sheet 3
TA147475
6-21
Back to Top
