TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 94 of 772
TM 9-2350-260-20-1-2
MAIN OIL FILTER REPLACEMENT (2A ENGINE) (Sheet 3 of 5)
CLEANING AND INSPECTION:
1.
Wash oil filter in dry cleaning solvent (Item 54, Appendix D).
2.
Remove all dirt from filter elements.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi.
Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves
etc.).
3.
Dry filter and blow out elements with low pressure compressed air.
4.
Inspect filter elements for breaks or tears in fine mesh screens.
5.
If filter is very dirty or f elements are damaged, disassemble filter and clean or replace damaged or dirty elements.
DISASSEMBLY:
1.
Using pliers, cut lockwire (A) and remove lockwire
(A) from bolt (B) and handle bracket.
2.
Using 9/16 inch wrench on bolt (B), remove bolt
(B) and gasket (C).
Throw gasket away and take
filter elements (D) off body (E).
Go on to Sheet 4
TA147471
6-17
Back to Top
