TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 266 of 783

TM 9-2350-260-20-1-3

HEADLIGHT HARNESS BASE ASSEMBLY REPLACEMENT (Sheet 2 of 4)

3.

Disconnect six electrical connectors (E) by pulling apart.

4.

Using 5/16 inch wrench, remove screw (F), lockwasher (G), and ground lead (H) from bracket (B) attached to inside of

front hull.

Throw lockwasher away.

5.

From outside of tank, using 7/16 inch wrench,

remove three screws (J) and fat washers (K)

securing base assembly (L) and gasket (M) to tank.

NOTE

When removing base (L) assembly,

pull seven leads (N) out one at a time.

If leads are taped together, remove

tape to allow leads to be removed

one at a time.

6.

Remove base assembly (L) and gasket (M).

Throw

gasket away.

Go on to Sheet 3

TA147286

10-254