TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 263 of 783

TM 9-2350-260-20-1-3

HEADLIGHT ASSEMBLY REPAIR (LEFT AND RIGHT) (Sheet 7 of 8)

NOTE

Make sure red and clear lenses (M)

are positioned as shown.

6.

Place headlight lens and seals (M) in notches

headlight cover (N) with rounded sides outward.

7.

Using Phillips screwdriver, install six screws (P) and

two retainers (Q) in position over two lenses (M) and

tighten.

NOTE

Make sure filter (T) is positioned

properly in blackout marker cavity (V)

properly.

8.

Using fingers, install seal (R), lens (S), seal (T), and

filter (U) in blackout marker cavity (V).

9.

Using Phillips screwdriver, install two screws (W)

with assembled washers to secure retainer (X).

10. Using fingers, install one seal (Y) in blackout

headlight shield (Z).

11. Using fingers, install blackout headlight lens (AA) in

position on blackout headlight shield (Z).

12. Using Phillips screwdriver, install other seal (Y) and

retainer (AB) into headlight she (2) with two screws

and lockwashers (AC).

Go on to Sheet 8

TA147283

10-251