TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 255 of 783

TM 9-2350-260-20-1-3

HEADLIGHT ADJUSTMENT (Sheet 2 of 2)

9.

Turn on service drive headlights, low beam

(TM 9-2350-260-10).

10. Center of maximum light intensity should be

centered on line (D).

11. If not, using 9/16 inch wrench, loosen three

screws (G) and adjust by tilting headlight (H)

to desired angle.

NOTE

Adjust both left and right headlights

in same manner.

12. Using 9/16 inch wrench, tighten three screws

(G).

13. Check to see if light intensity for left headlight

is centered on intersection of lines (D) and (E).

14. If not, using 7/16 inch wrench, loosen three

screws (J) at base of headlight.

15. Turn headlight (H) until in proper position.

16. Using 7/16 inch wrench, tighten three screws

(J) when adjusted.

17. Repeat steps 13 through 16 for right headlight,

using lines (D) and (F).

18. Turn off lights (TM 9-2350-260-10).

End of Task

TA147275

10-243