TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 292 of 783

TM 9-2350-260-20-1-3

ENGINE OIL HIGH PRESSURE TRANSMITTER REPLACEMENT (2D ENGINE)(Sheet 3 of 3)

INSTALLATION:

NOTE

Prior to installation, lightly coat male threads of all components with sealing

compound (Item 20, Appendix D).

1.

Using pipe wrench, install elbow (A) to engine.

2.

Using 3/4 inch wrench, install pipe bushing (B) to elbow (A).

3.

Using 7/8 inch wrench, install new transmitter (C) to pipe bushing (B).

4.

Lubricate connector (D) with silicone compound (Item 32, Appendix D).

5.

Push socket of rubber insulated connector (D) into transmitter cap (E).

6.

Remove rags from under engine oil high pressure transmitter.

7.

Connect engine for powerplant ground hop (page 5-54).

8.

Start and run engine.

Observe oil pressure indicator for normal oil pressure (TM 9-2350-260-10).

9.

Shut down engine.

Disconnect engine from powerplant ground hop (page 5-67).

10. Install powerplant (page 5-40).

End of Task

TA147312

10-280