TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 401 of 783

TM 9-2350-260-20-1-3

TRANSMISSION WIRING HARNESS REPLACEMENT (Sheet 4 of 7)

INSTALLATION:

NOTE

Perform steps 1 through 9 and 15

through 18 when transmission is

mated to 2D engine.

Perform steps 10 through 18 when

transmission is mated to 2A engine.

1.

Position wiring harness (A) onto powerplant as shown.

2.

Place six clamps (B) onto wiring harness at positions (C).

3.

Using hands, install new grommet (D) into rear engine shroud (E).

4.

Using spanner wrench, connect wiring harness connector (F).

Go on to Sheet 5

TA147421

10-389