TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 602 of 783

TM 9-2350-260-20-1-3

BRAKE EQUALIZER ASSEMBLY AND LINKAGE ASSEMBLES REPAIR AND REPLACEMENT

(Sheet 9 of 12)

NOTE

Steps 19 through 23 are procedures

for

assembly

of

rod

assembly

identified as rod assembly (Z) during

removal.

19. Install jamnut (R) and (S) onto rod (T).

20. Install rod end bearing (U) onto rod (T).

Adjust rod end bearing (U) on rod (T) so a 1/16 inch wire will not pass

through inspection hole in the shank of the rod end bearing.

21. Install rod end bearing (V) onto rod (T).

Adjust rod end bearing (V) until a measurement of 30 inches is obtained

between centers of rod end bearings (U) and (V).

22. Aline rod end bearings (U) and (V) as shown.

23. Using two 3/4 inch wrenches, tighten jamnuts (R) and (S) against rod end bearings (U) and (V).

Go on to Sheet 10

TA146362

13-74