TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 599 of 783

TM 9-2350-260-20-1-3

BRAKE EQUALIZER ASSEMBLY AND LINKAGE ASSEMBLES REPAIR AND REPLACEMENT

(Sheet 6 of 12)

CLEANING AND INSPECTION:

1.

Clean parts in dry cleaning solvent (Item 54, Appendix D).

2.

Inspect all parts for damage.

Replace all defective parts.

INSTALLATION:

NOTE

Steps 1 through 6 are procedures for

assembly of rod assembly identified

as rod assembly (R) during removal.

1.

Install jamnut (A) and (B) onto rod (C).

2.

Install rod end bearing (D) onto rod (C).

Adjust rod end bearing (D) on rod (C) so a 1/16 inch wire will not pass

through inspection hole in the shank of the rod end bearing (D).

3.

Install clevis (E) onto rod (C).

Adjust clevis until a measurement of 8-1/2 inches is obtained between end centers of

clevis (E) and rod end bearing (D).

4.

Aline clevis (E) and rod end bearing (D) of rod assembly as shown.

5.

Using slip joint pliers to hold clevis (E) and 15/16 inch wrench on jamnut (B), tighten jamnut (B) against clevis (E).

6.

Using 7/8 inch wrench to hold rod end bearing (D) and 15/16 inch wrench on jamnut (A), tighten jamnut (A) against

rod end bearing (D).

Go on to Sheet 7

TA146359

13-71