TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 600 of 783

TM 9-2350-260-20-1-3

BRAKE EQUALIZER ASSEMBLY AND LINKAGE ASSEMBLES REPAIR AND REPLACEMENT

(Sheet 7 of 12)

NOTE

Steps 7 through 12 are procedures

for

assembly

of

rod

assembly

identified as rod assembly (U) during

removal.

7.

Install jamnuts (F) and (G) onto rod (H).

8.

Install rod end bearing (J) onto rod (H).

Adjust rod end bearing (J) on rod (H) so a 1/16 inch wire will not pass through

inspection hole in the shank of the rod end bearing.

9.

Install clevis (K) onto rod (H).

Adjust clevis until a measurement of 8-3/4 inches obtained between end centers of

clevis (K) and rod end bearing (J).

10. Aline clevis (K) and rod end bearing (J) of rod assembly as shown.

11. Using slip joint pliers to hold clevis (K) and 3/4 inch wrench on jamnut (G), tighten jamnut (G) against clevis (K).

12. Using two 3/4 inch wrenches, tighten jamnut (F) against rod end bearing (J).

Go on to Sheet 8

TA146360

13-72