TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 504 of 1008

TM 9-2350-261-20-2

REPLACE BATTERY DRAWER INSULATION AND HEAT EXCHANGER

(M1064 ONLY) — Continued

0308 00

INSTALLATION

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

1.

Apply adhesive on insulation sheets. Wait 10-20 seconds until adhesive becomes tacky.

2.

If removed, install two insulation strips (2) and two insulation sheets (1) on battery drawer (3).

3.

If removed, install left insulation sheet (4), right insulation sheet (5), rear insulation sheet (6), bottom insulation sheet

(7), and top insulation sheet (8) in battery drawer shield (9).

4.

Place two clamps (10) on heat exchanger (11). Install heat exchanger in battery drawer (3).

0308 00-4