TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 908 of 1008

TM 9-2350-261-20-2

ADJUST PIVOT STEER LINKAGE — Continued

0415 00

4.

Pull master cylinder piston all the way in.

5.

Turntworodendbearings(1)untiltwoscrews (2) pass freely through two rod end bearings and two control handles (3).

6.

Turn two rod end bearings (1) one turn to the left to lengthen two rods (4). Obtain 1/32 in (0.8 mm) clearance between

master cylinder clevises (5) and master cylinder internal piston.

7.

Install two rod end bearing (1) on control handles (3). Secure with two screws (2) and new locknuts (6).

8.

Tighten locknuts (6) on rod end bearings (1).

CAUTION

Use FRH hydraulic fluid only (WP 0120 00).

9.

Remove two master cylinder filler caps (7). Fill master cylinders to 1/2-3/4 in (13-19 mm) from top. Install filler caps.

0415 00-2