TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 352 of 932

TM 9-2350-261-20-3

REPLACE TENT AND FRAME MOUNTS (M577A2 ONLY) — Continued

0505 00

3.

Install two clamps (6) and hand screws (7) on brackets (8). Secure with two washers (9), nuts (10), and new cotter

pins (11).

4.

Install two retainers (12) on brackets (8). Secure with two screws (13), washers (14), and new locknuts (15).

5.

Align two brackets (8) on rear bulkhead. Secure with four washers (16) and screws (17). TIGHTEN SCREWS TO

60-65 LB-FT (81-88 N·M) TORQUE. Use torque wrench.

6.

Align two end fittings (18) with rear bulkhead lugs. Secure with two screws (19), eight washers (20), and two new

locknuts (21)

FOLLOW-THROUGH STEPS

1.

Install tent frame on carrier (see your -10).

2.

Raise and lock ramp (see your -10).

3.

Stop engine (see your -10).

END OF TASK

0505 00-4