TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 78 of 932
REPLACE FLOOR PLATES (M1059 ONLY) — Continued
2.
Place two front floor plates (8) and (9) on hull crossmembers.
3.
Place two rear floor plates (10) and (11) on hull crossmembers.
4.
Install two washers (12) and screws (13) on front floor plates (8) and (9).
5.
Install 12 lined washers (14) and screws (15) on front floor plates (8) and (9), and rear floor plates (10) and (11).
FOLLOW-THROUGH STEPS
1.
Install personnel floor heater duct (WP 0617 00).
2.
Unstow seats (see your -10).
3.
Raise and lock ramp (see your -10).
END OF TASK
0438 00-4
0438 00
TM 9-2350-261-20-3
1.
If pads (1) through (5), rubber strips (6), or seals (7) were removed, apply light coat of adhesive to all crossmember
mating surfaces. Allow surfaces to become sticky. Install pads, rubber strips, and seals on crossmembers and press
surfaces firmly together.
Back to Top
