TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 70 of 932
TM 9-2350-261-20-3
REPLACE REAR FLOOR PLATES (M113A2 AND M577A2 ONLY) — Continued
0436 00
INSTALLATION
WARNING
Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These
compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you
dizzy and irritate your eyes and throat.
Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.
Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.
1.
If pads (6) and (7), strips (8), or seals (9) and (10) were removed, apply thin coat of adhesive to roughened side of rubber
surface. Allow to dry 20-40 minutes. Apply thin coat of adhesive to metal surface of hull crossmembers. Allow to dry
30-120 seconds. Install new pads, strips, and seals on crossmembers and press surfaces together firmly.
2.
Place rear floor plate (5) and two front floor plates (3) and (4) on hull crossmembers. Secure to hull with 16 lined
washers (2) and screws (1).
FOLLOW-THROUGH STEPS
1.
Install personnel heater floor duct, if removed (WP 0617 00).
2.
Raise and lock ramp (see your -10).
END OF TASK
0436 00-2
Back to Top
