TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 375 of 785

TM 9-2350-261-34

REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064 ONLY) — Continued

0054 00

INSTALLATION

1.

Install new anchor (1) with three new washers (2) and new screws (3).

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

2.

TIGHTEN SCREWS (3) TO 54-59 LB-FT (73-80 N·M) TORQUE. Use torque wrench. Use adhesive primer as

lubricant on threads and under screw heads.

3.

Install cylinder (4) on anchor (1) with headed pin (5). Secure with new cotter pin (6).

FOLLOW-THROUGH STEPS

1.

Install mortar turntable and ring gear. See TM 9-1015-232-23&P.

2.

Install mortar in carrier. See TM 9-1015-250-10.

3.

Raise and lock ramp (see your -10).

4.

Stop engine (see your -10).

END OF TASK

0054 00-4