TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 383 of 785

TM 9-2350-261-34

INSTALL PERSONNEL HEATER KIT (M113A2 AND M1059 ONLY) — Continued

0055 00

21. Install elbow (15) in heater intake pipe (12) and intake elbow (16).

22. Align inlet elbow (15) with intake elbow (16), and align exhaust pipe (14) with exhaust pipe in carrier. Place heater (2)

and shield (17) against saddles (5).

23. While still supporting heater, double check for proper mating of heater exhaust port (14) and exhaust pipe in carrier.

Tighten two saddle clamps (10).

NOTE

Heater Model A-20 has ground strap attached to top of heater.

24. Position ground strap (8) on heater (2) and secure with one lockwasher (18) and screw (19). Discard existing screw

and use kit screw.

25. Tighten clamp (13) on heater exhaust pipe (14) and exhaust pipe in carrier.

26. Tighten clamp (11) on heater intake pipe (12).

0055 00-6