TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 389 of 785

INSTALL PERSONNEL HEATER KIT (M113A2 AND M1059 ONLY) — Continued

62. Remove two screws (1) and control box (2) from control box case (3).

63. Remove two screws, nuts, and washers supplied with control box case (3). Discard screws, nuts, and washers.

64. Secure control box case (3) to two weldnuts (4) with two lockwashers (5) and screws (6).

65. Secure control box (2) to control box case (3) with two screws (1).

66. Clean small area on hull support next to control box (2) and apply warning decal (see your -20).

67. Thread personnel heater wiring harness (1) through transverse beam from driver’s compartment into personnel

compartment.

68. Connect personnel heater wiring harness (1) to control box (2).

69. Connect personnel heater wiring harness (1) to personnel heater (3).

70. Install shell (4) and washer (5) on control box lead (6).

71. Connect circuit 400 lead (7) of rear main wiring harness (8) to control box lead (6).

72. Connect circuit 402 lead (9) of rear main wiring harness (8) to fuel pump lead (10) and to connector (11) of personnel

heater wiring harness (1).

73. Remove clip (12) securing battery cable (13) and radio cable (14) to cradle (15). Discard clip.

74. Remove screw (16) and cradle (15) from weldnut (17). Discard cradle.

75. Install clamp (18) on battery cable (13), radio cable (14), and personnel heater wiring harness (1).

0055 00-12

0055 00

TM 9-2350-261-34